eVolve Electrical v3.0.5 HotFix

Release Date 07/12/2019

Resources

Compatibility

  • Autodesk® Revit® 2018.3
  • Autodesk® Revit® 2019

General Enhancements

  • eE_Project_Template.rte
    • - Updated bend schedule filtering
    • - Updated bend legends
  • eE_Family_Template
    • - updated point family
  • eE_Family_Template_FB
    • -updated point family

New Families Added

  • eE_HW_Steel_Rectangular
    • - 1/8in Rectangular Steel 1 x 2
    • - 1/8in Rectangular Steel 1 x 3
    • - 1/8in Rectangular Steel 1 x 4
    • - 1/8in Rectangular Steel 2 x 3
    • - 1/8in Rectangular Steel 2 x 4
    • - 1/4in Rectangular Steel 1 x 2
    • - 1/4in Rectangular Steel 1 x 3
    • - 1/4in Rectangular Steel 1 x 4
    • - 1/4in Rectangular Steel 2 x 3
    • - 1/4in Rectangular Steel 2 x 4
  • eE_HW_Square_Washer
    • - Square Washer Egalve
    • - Square Washer Gold
    • - Square Washer Stainless

Existing Family Updates

  • eE_SV_Conduit_Deck_Sleeve
    • - fixed nested layout point not properly linked
  • eE_ASM_HS_Mini_Hanger
    • - fixed nested layout point not properly linked
  • eE_CN_Kick_90_v2
    • - add LF conduit description to track in BOM
    • - corrected connector misalignment for kick heights < 2"
    • - User adjustable nose minimum length
    • - Added coupling end options
  • eE_CN_Offset_v2
    • - fix 4" angle issue causing smaller offsets to look off with 4" conduit
    • - now flip conduit Up Down (and roll), or horizontal left/Right.
    • - set overall length (instead of just tail length)
    • - switch the pivot point of the offset (with indicator on which end is the active pivot point)
    • - User adjustable nose minimum length
  • eE_CN_Stub_90_v2
    • - User adjustable nose minimum length
    • - Updated bend formulas
    • - Created "Angled" bend schedule with bend information
  • eE_HW_Channel_Nut_Assembly
    • - fix graphical issue with bolt gap not adjusting
    • - Add additional bolt length parameters.
  • eV_Point
    • - added instance parameter to change from 'sphere' to 'crosshair'
  • eE_SB_B341_4H_Splice_Plate
    • - adjusted Sub Category to "Flat Plate"


How did we do?


Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)