Threaded Rod Assembly

Assembly Overview

Instance Properties

  • Mounting Length- Length from the top of the strut to the top of the rod

Upper Attachment
  • Beam Clamp
  • Beam Clamp Rotate- to rotate the beam clamp, enter the degrees to rotate it from its current position.
  • Channel Nut Top
  • Blue Banger

Lower Attachment
  • Show Lower Attachment- Turns on the configurable lower attachment
  • Strut Attachment- Check this box to configure the bottom attachments to fit one of the following sizes of strut. (Select One)
  • Strut 7/8"
  • Strut 1-5/8"
  • Strut 2-7/16"
  • Strut 3-1/4"
  • Strut Back to Back- Any of the available strut sizes can be shown as back to back strut
  • Channel Nut Bottom- Check this box to configure the bottom attachment to utilize a channel nut on the bottom
  • Box Attachment- Check this box to configure the bottom attachment to utilize a configurable box attachment assembly
  • Box Thickness- if using the box attachment, this parameter is where the box thickness is set
  • Rod Offset Bottom- The distance from the bottom of the rod to the inside face of the box
  • Square Washer Top- For any lower attachment, turns the top square washer on or off
  • Square Washer Bottom- For any lower attachment, turns the bottom square washer on or off

Layout Points
  • Layout Point Id- Will not be available until points have been numbered in the Points Manager
  • Layout Point Description- A user definable description for keeping track of where layout points were placed

Type Properties

Hardware Size- Change the size of the rod and hardware from one of the following sizes

  • eVolve Hardware 1/4"
  • eVolve Hardware 3/8"
  • eVolve Hardware 1/2"

Extras

  • Show Zone of Influence- Turns on a clearance zone around the top attachment area
  • ZOI Diameter- Adjust the diameter of the clearance zone
  • ZOI Length- Adjust the length of the clearance zone
  • Show Layout Point- Turns on and shows a layout point at the top of the assembly


How did we do?


Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)