Concentric Bends

Converts modeled Stub 90 bends into concentric bends.

IMPORTANT: This feature requires the use of the eE_CN_Stub_90_v12 family or higher.

To convert (pre-selection)

  1. From the drawing area, select the desired group of stub 90 bends.
  2. From the Electrical ribbon, in the Conduit Bends panel, click Concentric Bends.

NOTE: If some or all of the select bends have been converted, a dialog will appear to either:

  • Update selection to concentric bends (used to update bend information due to additional bends being added to the run and/or the parallel spacing has been modified).
  • Reset bends to standard radii (used to revert selected bends to the default radii)

To convert

  1. From the Electrical ribbon, in the Conduit Bends panel, click Concentric Bends.
  2. From the drawing area, select the desired group of stub 90 bends.
  3. From the options bar, click 'Finish'

NOTE: If some or all of the select bends have been converted, a dialog will appear to either:

  • Update selection to concentric bends (used to update bend information due to additional bends being added to the run and/or the parallel spacing has been modified).
  • Reset bends to standard radii (used to revert selected bends to the default radii)


How did we do?


Powered by HelpDocs (opens in a new tab)