Knowledge Base > User Guides > Conduit
The eVolve Place Coupling Feature. Once again, eVolve has added a new time saving feature. Users can now draw conduit runs without fittings, using factory elbows, and at any time click a button to pl…
Updated 2 weeks ago by Adam Heon
eVolve System Colors. The Show System Colors and the Clear System Colors buttons have been added to allow users to quickly turn on or shut off the system raceway colors that were setup in the Project…
Updated 2 months ago by Adam Heon
The Align Conduit button is able to align multiple runs of conduits. Conduits may be aligned by elevation or have spacing applied. Currently, when aligning by elevation, only horizontal spacing is ap…
eVolve Assign Run Id. The eVolve Assign Run Id feature allows users to quickly assign Conduit Run Schedule values to a conduit run. When applied, the schedule values will sync with the eVolve_Conduit…
Apply Elevation Alignment. Allows conduits to align to the top or bottom of a specified edge or conduit. Align to Top - adjusts selected conduits to the outer upper point of a specified edge or condu…
eVolve Clear Run Id. This quick, time saving feature will clear all of the eVolve Run Id parameters of the selected connected run(s). From the eVolve Electrical ribbon, in the Conduit panel, click Cl…
eVolve Draw Conduit. eVolve Electrical has taken Revit’s basic conduit feature and enhanced it to load preconfigured eVolve conduit families. eVolve automatically adds drawn conduit and fittings into…
eVolve Conduit Run Schedule. The eVolve Conduit Run Schedule is designed to create, modify, and manage conduit run data. Schedule data can be entered manually or loaded from a pre-configured excel fi…
eVolve Conduit Error Check. Analyzes the model for inaccuracies, highlighting mistakes as compared to the Conduit Run Schedule. The Error Check function performs the following checks: Run Id Not Sche…
Updated 2 months ago by Kerry Poe
eVolve Conduit Reset View. If an Error Check has been performed in the project, clicking the Reset View Button will return the highlighted conduit runs to their original state. To Perform a Conduit R…
Updated 10 months ago by Adam Heon
When the option to Enable Conduit Run Schedule Lenght Calculations is turned off, Revit will not update the conduit length parameters if a length change is made. The Refresh Conduit Length tool can u…
Updated 1 month ago by Adam Heon
Powered by HelpDocs (opens in a new tab)
Updated 2 months ago
by Adam Heon
