Place Sleeve

When only a few sleeves need to be placed, there is no need to create an extra rule inside of Sleeve Settings. Simply use the Place Sleeves command for quick placement options.

  1. From the Penetrations panel, in the eVolve Electrical ribbon, click Place Sleeves
  2. Select the locations to place the sleeves.
  3. Enter placement options

  • Sleeve Family - Specify which Sleeve Family to use.
  • Sleeve Type - Specify which family type to use for the sleeve
  • Extension Values - Enter optional oversizing values for your sleeve
  • Load from PreDefined - Choose to use an existing rule sets in sleeve settings to populate this info.

The Extension Values options shown will vary depending on if it is a Round or Rectangular Sleeve
The Sleeve Family options will show any sleeves that is of the eVolve SubCategory Sleeves


How did we do?


Powered by HelpDocs (opens in a new tab)

Powered by HelpDocs (opens in a new tab)